Cirago CDD3000 Manuel d'utilisateur Page 1

Dual Hard Drive Docking Station CDD3000 User Manual

b) CloneDrive activated, click “Start” c) Press start to proceed with Clone

d) Clone progress is displayed e) Click “OK” once clone is finished

f) You should find the same contents of Source HDD in Target HDD g) If your target HDD has extra space, the system will allocate

HDD Partition a) Open Disk management and select the unallocated area b) Right click “New partition” for further action

c) “Next” d) Base on your need and click “Next”

e) Please enter the new partition capacity and click “Next” for further action f) Assign the drive letter and “Next”

g) Select “Quick Format” to format the new partition h) Click “Finish”

i) mPartition completed, the new partition can be found.

Limited Warranty This is to certify that this Product is free of congenital defects in materials and workmanship. Cirago’s Limited w

7. All damaged parts will become Cirago’s property. 8. Free warranty service will not be provided if: i) The Product has been explicitly

Introduction： CDD3000 is a USB 3.0 dual-SATA 2.0 hard drive docking station. It supports simultaneous use of two 2.5” or 3.5” SATA hard disks

Note: When using E-SATA interface, the PC can only recognize one HDD in the docking station. If two HDDs are in the docking station,

CLONE: Please note the below conditions before clone: - Slot ‘A’ = SOURCE HDD - Slot ‘B’ = TARGET HDD - TARGET HDD’s capacity MUST be larger

b) Once the Slot indicators are on, that means CDD3000 is ready for cloning. c) Press and hold the clone button fo

d) Clone progress indicator flashes and shows the progress (25%, 50%, 75%, 100%). e) Once cloning is finished, all progress

2) Cloning with USB Software Installation (Windows only) a) Please insert the CD drive and click “setup.exe”. Choose your language and

c) Click “Install” to begin installation d) Installation progress is displayed

e) Click “Done” once installation is finished Clone from Source HDD to Target HDD a) Insert Source HDD and Target HDD into the d